Droideka schematic

[Gordlad]

Not sure if this is a bug or not so posting it here first.

I created a combat droideka and experimented fully on it and the HAM stayed at the default 1500. Not sure what I did wrong because there is a droideka on the baz that has a higher HAM. When I look at my schematic there is no experimental stats for the droideka like there are for other droids. I tried several different chemicals as this is all that it takes for the final combine besides the sub-components and none of them seem to effect the quality.


In this first picture you can see that the probot has experimental effects from the quality of the resource.


In this second picture for the droideka you can see that there are no experimental effects from the quality of the resource. Again, I tried several different chemicals with all of them giving the same results.

[TheTinyPebble]

The resource weights not showing is a known issue.

OQ determines the amount of HAM during the experimental final combine, experiment on the middle tree.

[rofilrosso]

i know that issue but it's only a graphic stuff, when this happen you should have a look on the stats that the component, droid o wathever is using on the right part of the crafting window when you have to choise materials for the assembly (you could scrool down a bit for show them if you don't see those stats), then you would match the best mat than got those stats, depending witch experimentation you want to priorize, for droid yeah, it's OQ for HAM increrase cause it pimp up experimental effectiveness.